Pool Lights & Spa Repairs
Hardwired pool light installs and full spa servicing, from jets and heaters to pumps and controls.
Two different parts of a pool, covered together here since both involve electrical components sitting close to water, and both need that side of the job taken seriously.
Pool Lights
Pool light installs are hardwired, not battery or solar units, for a fixture that's actually reliable long term. That covers both new installs and replacing existing lights that have failed or need upgrading.
A typical pool light setup runs from a dedicated circuit through a junction box positioned well back from the pool edge, then through conduit embedded in the pool shell to the light fitting itself. Most modern fittings are LED, run on a low voltage transformer, and last considerably longer than older incandescent or halogen bulbs, which have a much shorter working life by comparison.
Battery and solar pool lights are convenient to fit but tend to dim, fail, or need attention far sooner than a hardwired fixture does. Common faults on any pool light include a failed seal letting water into the fitting, a worn out bulb or LED module, or a fault in the transformer itself, which usually can't be repaired and needs replacing outright. Hardwiring costs more upfront to install properly, but it's the difference between a light that's still doing its job in years to come and one that's back to being a problem within a season or two.
Signs a pool light needs attention
- ✓Dimming, flickering, or a light that's noticeably weaker than it used to be
- ✓Fogging or moisture visible inside the light housing
- ✓A light that's stopped working altogether
Spa Repairs
Spa pumps, heaters, jets, and controls are all serviced and repaired. If your spa isn't heating, isn't circulating properly, or a component's failed, get in touch to talk through what's going on.
A spa's circulation pump pushes water through the jets and, importantly, through the heater. Most spa heaters are built to only run while water is flowing past them, so if circulation is interrupted, whether from a clogged filter, an airlock in the plumbing, or debris caught in the impeller, the heater will typically shut itself off rather than run dry. That's often why a spa that's suddenly not heating turns out to be a circulation problem rather than a heater fault.
Most spa issues show up as one of a few patterns: jets losing pressure or stopping altogether, a heater that's running but not actually getting the water to temperature, or a control panel throwing an error or just not responding. Whatever the symptom, the same approach applies as everything else here: work out what's actually wrong before anything gets replaced.
The Electrical Side
Both pool lights and spa equipment sit close to water and draw mains power, which is exactly the kind of work that needs to be done properly. Pool electrical wiring requires a licensed electrician in New Zealand, so any job involving new circuits, rewiring, or work at the switchboard is carried out or signed off by a licensed electrician as part of the job, not skipped or worked around.
Photo: a newly installed hardwired pool light
Photo: spa equipment serviced on site
Frequently Asked Questions
Why is my pool light dim or flickering?
Common faults include a failed seal letting water into the fitting, a worn out bulb or LED module, or a fault in the transformer itself, which usually can't be repaired and needs replacing outright.
Are hardwired pool lights better than solar or battery ones?
Battery and solar pool lights are convenient to fit but tend to dim, fail, or need attention far sooner than a hardwired fixture does. Hardwiring costs more upfront but it's the difference between a light that's still doing its job in years to come and one that's back to being a problem within a season or two.
Why has my spa stopped heating?
Often turns out to be a circulation problem rather than a heater fault. Most spa heaters are built to only run while water is flowing past them, so interrupted circulation, a clogged filter, an airlock, or debris in the impeller, will typically make the heater shut itself off rather than run dry.
Do pool lights and spa repairs need a licensed electrician?
Any job involving new circuits, rewiring, or work at the switchboard is carried out or signed off by a licensed electrician, since pool electrical wiring requires one in New Zealand.
What's different about maintaining a spa pool compared to a swimming pool?
Spas run hotter with a much smaller volume of water, so chemical levels swing faster and need checking more often.
Related Services
Light Playing Up, or Spa Not Right?
Get in touch with what you're noticing and we'll talk through what it's likely to be before booking anything in.
Get a QuoteLooking for something else? See all repairs & installs.